Keeping in mind ever-evolving requirements of our respected clients, we are providing a premium quality range of Water Detection Panel.
Technical Features:
Detection:
- Up to 8 zones
- 22uF capacitor EOL monitoring
- 680 ohm resistor activation for zones
- Latching alarms on detection of water
- Zone 1 non latching alarm option set via on board panel configuration option switches
Alarm Sounder O/P:
- 2 x fully monitored sounder (bell/alarm) circuits (1 and 2 zone panels)
- 4 x fully monitored sounder (bell/alarm) circuits (4 and 8 zone panels)
Auxiliary Outputs:
- 1 x volt free no/nc alarm relay contacts
- 1 x volt free no/nc relay contacts
User Controls:
- Silence Buzzer/Alarms,
- Alarm Sounder Test
- System Reset
- Zone Isolate
- controls activated/deactivated by engineers access code
Indications:
- Leak zone
- Zone fault/isolated
- Engineers controls active
- System healthy
- Alarm fault
- Processor fault
- Battery fault
- Earth fault
- One man test
- Repeater fault
Power Supply:
- Fault monitored 230Vac 50/60Hz with built in fault monitored backup battery charger
Panel Housing:
- Light grey textured polycarbonate 3 part enclosure with blue display inset
- 4mm cross point fixing bolts on covers
- Top gland plate with 20mm knockouts
Other details:
- The Signaline CB200W Water Detection Panel monitors up to 8 Signaline WDM KM Control Modules each of which controls up to 1000m of Signaline WD Water Detection Cable
- The Signaline WD Water Detection Cable is best suited to areas such as floors, floor voids, ducts and suspended ceilings
- When the detection cable senses water the control panel will initiate an alarm. In addition the Signaline CB200W Water Detection Panel will monitor for open/short circuit faults within the detection cable, and also for control module failure
