Water Leak Detection Panel

Keeping in mind ever-evolving requirements of our respected clients, we are providing a premium quality range of Water Detection Panel.

Technical Features:

Detection:

• Up to 8 zones
• 22uF capacitor EOL monitoring
• 680 ohm resistor activation for zones
• Latching alarms on detection of water
• Zone 1 non latching alarm option set via on board panel configuration option switches

Alarm Sounder O/P:

• 2 x fully monitored sounder (bell/alarm) circuits (1 and 2 zone panels)
• 4 x fully monitored sounder (bell/alarm) circuits (4 and 8 zone panels)

Auxiliary Outputs:

• 1 x volt free no/nc alarm relay contacts
• 1 x volt free no/nc relay contacts

User Controls:

• Silence Buzzer/Alarms,
• Alarm Sounder Test
• System Reset
• Zone Isolate
• controls activated/deactivated by engineers access code

Indications:

• Leak zone
• Zone fault/isolated
• Engineers controls active
• System healthy
• Alarm fault
• Processor fault
• Battery fault
• Earth fault
• One man test
• Repeater fault

Power Supply:

• Fault monitored 230Vac 50/60Hz with built in fault monitored backup battery charger

Panel Housing:

• Light grey textured polycarbonate 3 part enclosure with blue display inset
• 4mm cross point fixing bolts on covers
• Top gland plate with 20mm knockouts

Other details:

• The Signaline CB200W Water Detection Panel monitors up to 8 Signaline WDM KM Control Modules each of which controls up to 1000m of Signaline WD Water Detection Cable
• The Signaline WD Water Detection Cable is best suited to areas such as floors, floor voids, ducts and suspended ceilings
• When the detection cable senses water the control panel will initiate an alarm. In addition the Signaline CB200W Water Detection Panel will monitor for open/short circuit faults within the detection cable, and also for control module failure